Junction box with M20 gland holes and lid
CADlingo generated this model from the prompt below. Open it in the studio to inspect it in 3D and view sections.
The prompt
Wall-mounted junction box with a screw-on lid, two separate solids. Frame: box X=-50..50, Y=-50..50, Z=0..50, walls 3 mm, floor 3 mm, outer vertical edges rounded R4. Four lid screw bosses Ø8 in the inside corners, centred at (±42, ±42), full height Z=3..50, each with a Ø2.8 pilot hole 12 mm deep from the top for M3.5 screws. Two Ø20.5 cable gland holes for M20 glands go through the wall at Y=-50, centred at X=±22, Z=25. Two Ø4.5 wall mounting holes go through the floor at (0, ±30), each with a 90° countersink Ø9 on the inside face. Lid: a 4 mm plate X=-50..50, Y=-50..50, Z=50..54 with R4 corners and four Ø3.8 clearance holes on the boss centres, each with a Ø7 x 2 mm counterbore from the top.Model facts
- Overall size
- 100 × 100 × 54 mm
- Bodies
- 2
- Volume
- 135.7 cm³
Download
Check the geometry and dimensions in your own CAD tool or slicer before you make or use this part.





