← Examples
Pipe & hose fittings

Hose barb reducer, 12 to 8 mm

CADlingo generated this model from the prompt below. Open it in the studio to inspect it in 3D and view sections.

The prompt

Straight hose barb reducer from 12 mm to 8 mm hose, one solid. Frame: the axis is Z. Make the round part by drawing the whole outer profile in the XZ plane and revolving it 360° around Z, so all barbs and both ends are one solid: small end Z=-25..0 for 8 mm inside-diameter hose with three barbs, each 8 mm long, rising from Ø7.2 at its leading edge to Ø9 at its back and then stepping straight down to Ø7.2 (first barb starts at the tip Z=-25, the remaining 1 mm up to Z=0 is a Ø9 land); large end Z=8..33 for 12 mm hose with three barbs from Ø11 to Ø13.5, the first starting at the tip Z=33 (a Ø11 land fills the last 1 mm down to Z=8). Join a hex 17 mm across flats at Z=0..8 to that revolved body. Finally cut the through bore: Ø8 from Z=0 to Z=33 and Ø5 from Z=-25 to Z=0.

Model facts

Overall size
19.6 × 17 × 58 mm
Bodies
1
Volume
4.1 cm³

Download

Check the geometry and dimensions in your own CAD tool or slicer before you make or use this part.

Open in studio

Have a part in mind?

Open an example or describe a part you actually need.

Free credits and current offers