← 作例
配管・ホース部品

異径ホースニップル、12→8 mm

CADlingoが下のプロンプトから生成したモデルです。スタジオで開くと、3Dでの確認や断面表示ができます。

プロンプト

Straight hose barb reducer from 12 mm to 8 mm hose, one solid. Frame: the axis is Z. Make the round part by drawing the whole outer profile in the XZ plane and revolving it 360° around Z, so all barbs and both ends are one solid: small end Z=-25..0 for 8 mm inside-diameter hose with three barbs, each 8 mm long, rising from Ø7.2 at its leading edge to Ø9 at its back and then stepping straight down to Ø7.2 (first barb starts at the tip Z=-25, the remaining 1 mm up to Z=0 is a Ø9 land); large end Z=8..33 for 12 mm hose with three barbs from Ø11 to Ø13.5, the first starting at the tip Z=33 (a Ø11 land fills the last 1 mm down to Z=8). Join a hex 17 mm across flats at Z=0..8 to that revolved body. Finally cut the through bore: Ø8 from Z=0 to Z=33 and Ø5 from Z=-25 to Z=0.

モデル情報

全体サイズ
19.6 × 17 × 58 mm
ボディ数
1
体積
4.1 cm³

ダウンロード

製作や使用の前に、お使いの CAD ツールまたはスライサーで形状と寸法を確認してください。

スタジオで開く

つくりたい部品はありますか?

サンプルを開くか、必要な部品を言葉で伝えてみてください。

無料クレジット・キャンペーン情報