One-hole strap for a Ø22 pipe
CADlingo generated this model from the prompt below. Open it in the studio to inspect it in 3D and view sections.
The prompt
One-hole pipe strap for a Ø22 copper pipe, made as one solid from 2 mm sheet. Build it as one profile extruded along X: in the YZ plane, draw a 2 mm thick strip that follows this centreline: start at the foot end (Y=-19, Z=1), run along Z=1 to Y=-12, up the line Y=-12 to Z=11, over the top as a half circle of radius 12 centred at (Y=0, Z=11), down the line Y=12 to Z=1, then along Z=1 to Y=35. Extrude this profile 16 mm along X (X=-8..8) so the strap wraps over a pipe whose axis is X at Y=0, Z=11, resting on the wall plane Z=0. Then cut one Ø5 screw hole through the flat tab at Y=26, X=0, and round the two tab-end corners at Y=35 with R8.Model facts
- Overall size
- 16 × 54 × 24 mm
- Bodies
- 1
- Volume
- 2.7 cm³
Download
Check the geometry and dimensions in your own CAD tool or slicer before you make or use this part.



