Ø22 배관용 원홀 새들
CADlingo가 아래 프롬프트로 만든 모델입니다. 스튜디오에서 열면 3D로 살펴보고 단면을 확인할 수 있습니다.
프롬프트
One-hole pipe strap for a Ø22 copper pipe, made as one solid from 2 mm sheet. Build it as one profile extruded along X: in the YZ plane, draw a 2 mm thick strip that follows this centreline: start at the foot end (Y=-19, Z=1), run along Z=1 to Y=-12, up the line Y=-12 to Z=11, over the top as a half circle of radius 12 centred at (Y=0, Z=11), down the line Y=12 to Z=1, then along Z=1 to Y=35. Extrude this profile 16 mm along X (X=-8..8) so the strap wraps over a pipe whose axis is X at Y=0, Z=11, resting on the wall plane Z=0. Then cut one Ø5 screw hole through the flat tab at Y=26, X=0, and round the two tab-end corners at Y=35 with R8.모델 정보
- 전체 크기
- 16 × 54 × 24 mm
- 바디 수
- 1
- 부피
- 2.7 cm³
다운로드
제작하거나 사용하기 전에 사용하는 CAD 도구나 슬라이서에서 형상과 치수를 확인하세요.



