← 예시
메이커·전자기기

70 × 50 mm PCB 케이스와 뚜껑

CADlingo가 아래 프롬프트로 만든 모델입니다. 스튜디오에서 열면 3D로 살펴보고 단면을 확인할 수 있습니다.

프롬프트

Enclosure for a 70 x 50 mm prototype PCB, two separate solids: base and lid. Frame: base X=-40..40, Y=-30..30, Z=0..28, walls 2 mm, floor 2 mm, outer vertical edges rounded R3. Inside the base, four standoffs Ø6 x 5 mm tall rise from the floor (Z=2..7) on a 66 x 46 mm pattern centred on the origin, each with a Ø2.5 pilot hole 5 mm deep for M3 screws. The PCB sits on the standoffs at Z=7. The short wall at X=-40 has a 12 x 7 mm rectangular opening for a USB cable centred at Y=0, Z=11. The long wall at Y=-30 has a row of five vent slots 2 x 14 mm, vertical, centred at Z=18, spaced 6 mm along X around X=0. Lid: a 2 mm plate X=-40..40, Y=-30..30, Z=28..30 with the same R3 corners, plus a 2 mm tall locating lip under it (Z=26..28) that fits inside the walls with 0.2 mm clearance per side (lip outer 75.6 x 55.6, 1.5 mm thick).

모델 정보

전체 크기
80 × 60 × 30 mm
바디 수
2
부피
33.9 cm³

다운로드

제작하거나 사용하기 전에 사용하는 CAD 도구나 슬라이서에서 형상과 치수를 확인하세요.

스튜디오에서 열기

만들고 싶은 부품이 있나요?

예제를 열어보거나 실제 필요한 부품을 설명해보세요.

무료 크레딧·프로모션 안내