← Examples
Jigs & fixtures

V-block drill jig for a Ø25 bar

CADlingo generated this model from the prompt below. Open it in the studio to inspect it in 3D and view sections.

The prompt

V-block drill jig for a Ø25 mm round bar, one solid. Frame: block X=-40..40, Y=-25..25, Z=0..40; the bar axis runs along X under the block. A 90° V-groove is cut into the bottom face along the full X length, centred on Y=0, 15 mm deep (30 mm wide at Z=0). Two vertical Ø6 drill guide holes go from the top face into the groove at X=-15 and X=15, Y=0, each with a Ø10 x 5 mm deep counterbore from the top for a press-fit bushing. Two M5 clearance holes go through along Z in the flat strips beside the groove, at (X=-32, Y=20) and (X=32, Y=-20).

Model facts

Overall size
80 × 50 × 40 mm
Bodies
1
Volume
138.0 cm³

Download

Check the geometry and dimensions in your own CAD tool or slicer before you make or use this part.

Open in studio

Have a part in mind?

Open an example or describe a part you actually need.

Free credits and current offers