← 예시
지그·고정구

Ø25 봉재용 V블록 드릴 지그

CADlingo가 아래 프롬프트로 만든 모델입니다. 스튜디오에서 열면 3D로 살펴보고 단면을 확인할 수 있습니다.

프롬프트

V-block drill jig for a Ø25 mm round bar, one solid. Frame: block X=-40..40, Y=-25..25, Z=0..40; the bar axis runs along X under the block. A 90° V-groove is cut into the bottom face along the full X length, centred on Y=0, 15 mm deep (30 mm wide at Z=0). Two vertical Ø6 drill guide holes go from the top face into the groove at X=-15 and X=15, Y=0, each with a Ø10 x 5 mm deep counterbore from the top for a press-fit bushing. Two M5 clearance holes go through along Z in the flat strips beside the groove, at (X=-32, Y=20) and (X=32, Y=-20).

모델 정보

전체 크기
80 × 50 × 40 mm
바디 수
1
부피
138.0 cm³

다운로드

제작하거나 사용하기 전에 사용하는 CAD 도구나 슬라이서에서 형상과 치수를 확인하세요.

스튜디오에서 열기

만들고 싶은 부품이 있나요?

예제를 열어보거나 실제 필요한 부품을 설명해보세요.

무료 크레딧·프로모션 안내