← 예시
지그·고정구

18 mm 판재용 목다보 드릴 지그

CADlingo가 아래 프롬프트로 만든 모델입니다. 스튜디오에서 열면 3D로 살펴보고 단면을 확인할 수 있습니다.

프롬프트

Dowel drilling jig for the edge of an 18 mm board, one solid. Frame: X runs along the board edge, the jig spans X=-60..60. A guide block X=-60..60, Y=0..24, Z=0..25 sits on the board edge (the edge is the plane Z=0, the board occupies Y=0..18 below Z=0). A fence plate X=-60..60, Y=-6..0, Z=-30..25 hangs down along the board face Y=0. Three vertical Ø8 guide holes go through the block along Z at X=-32, 0 and 32, centred on Y=9 (the middle of the board). Each guide hole has a 1 x 45° chamfer at the top. Two Ø5 clamp holes go through the fence plate along Y at X=-48 and X=48, Z=-15. Round all outside edges of the block with R1.

모델 정보

전체 크기
120 × 30 × 55 mm
바디 수
1
부피
107.4 cm³

다운로드

제작하거나 사용하기 전에 사용하는 CAD 도구나 슬라이서에서 형상과 치수를 확인하세요.

스튜디오에서 열기

만들고 싶은 부품이 있나요?

예제를 열어보거나 실제 필요한 부품을 설명해보세요.

무료 크레딧·프로모션 안내