← 作例
治具・取付具

Ø25丸棒用Vブロックドリル治具

CADlingoが下のプロンプトから生成したモデルです。スタジオで開くと、3Dでの確認や断面表示ができます。

プロンプト

V-block drill jig for a Ø25 mm round bar, one solid. Frame: block X=-40..40, Y=-25..25, Z=0..40; the bar axis runs along X under the block. A 90° V-groove is cut into the bottom face along the full X length, centred on Y=0, 15 mm deep (30 mm wide at Z=0). Two vertical Ø6 drill guide holes go from the top face into the groove at X=-15 and X=15, Y=0, each with a Ø10 x 5 mm deep counterbore from the top for a press-fit bushing. Two M5 clearance holes go through along Z in the flat strips beside the groove, at (X=-32, Y=20) and (X=32, Y=-20).

モデル情報

全体サイズ
80 × 50 × 40 mm
ボディ数
1
体積
138.0 cm³

ダウンロード

製作や使用の前に、お使いの CAD ツールまたはスライサーで形状と寸法を確認してください。

スタジオで開く

つくりたい部品はありますか?

サンプルを開くか、必要な部品を言葉で伝えてみてください。

無料クレジット・キャンペーン情報