A case can match a board’s outline and still be unusable if a plug cannot reach its connector. Before drawing vents or choosing corner radii, mark the interfaces: where the board rests, where cables enter, and where the lid closes. A top view alone leaves several of these undecided.
Give the sketch a top view and a side section
| View | Add to the sketch | What it resolves |
|---|---|---|
| Top | Board outline, mounting-hole centers, connector edges | Board placement and lateral access |
| Side section | Floor, standoff height, board level, tallest component, lid underside | Vertical clearance and connector height |
| Cable approach | Plug body and insertion direction | Whether a correctly placed opening is actually accessible |
Use the drawing for your board revision and the connectors and cooler you intend to fit. Distinguish dimensions you measured from provisional clearances. Leave unknown values labelled as assumptions rather than hiding them in an apparently precise sketch.
What the saved case tells us
The linked model starts from “Raspberry Pi 5 case with side vents, 4 standoffs.” Its controls expose wall thickness, standoff height and vent width. In this saved program the cavity stays 88 × 60 mm while the outer size grows with wall thickness. At a 2.5 mm wall, the nominal base footprint is 93 × 65 mm; at 3 mm it becomes 94 × 66 mm.
That is a useful design choice if you want to preserve board space. It is the opposite of a fixed outer enclosure, where a thicker wall consumes internal space. Decide which envelope must remain fixed before requesting a change.
Turn the marked views into a change request
Use the attached top view for the board position and hole centers, and the side section for the board height. Keep those interfaces fixed. Make the cable opening clear the measured plug envelope. Keep the lid and base separate, and identify any clearance you have to assume.
This is a suggested brief, not a recorded sketch-to-CAD result. After generation, inspect the standoffs, connector openings and lid overlap separately. A rendering of the closed case cannot show whether all three are correct. A saved example also does not establish fit with your physical board.
Revise one interface with its dependencies
Raising a standoff can move the board and therefore the connector level. Enlarging a vent near a lid lip can remove material needed for closure. Name the interface to preserve in the request, and compare that region with the board or plug drawing. For the mechanics of direct numeric edits, use the separate parameter guide.
See a real dimension-edit preview
See a board enclosure with standoffs, openings and a fitted lid
