← 예시
메커니즘·조립품

평행 그리퍼 핑거 한 쌍

CADlingo가 아래 프롬프트로 만든 모델입니다. 스튜디오에서 열면 3D로 살펴보고 단면을 확인할 수 있습니다.

프롬프트

Pair of parallel-gripper fingers as two separate solids, mirror images across the plane Y=0. Each finger: X=0..60, Z=-10..10 (20 mm wide), 12 mm thick along Y; in the modeled open position the gripping faces are at Y=10 and Y=-10, facing each other. At the tip end (X=36..60) each gripping face has a 120° V-notch running along Z, 5 mm deep, centred at X=48, so round parts from Ø10 to Ø30 seat in both notches as the fingers close. Each finger has two M4 counterbored mounting holes through its thickness along Y at X=8 and X=28, Z=0, counterbored from the outer face.

모델 정보

전체 크기
60 × 44 × 20 mm
바디 수
2
부피
25.7 cm³

다운로드

제작하거나 사용하기 전에 사용하는 CAD 도구나 슬라이서에서 형상과 치수를 확인하세요.

스튜디오에서 열기

만들고 싶은 부품이 있나요?

예제를 열어보거나 실제 필요한 부품을 설명해보세요.

무료 크레딧·프로모션 안내