When requesting a Geneva mechanism in text, specify the slot count, drive pin size and position, center distance between the two rotation axes, and angular references for the assembly separately. CADlingo’s public Geneva drive example provides an input prompt that defines these conditions with coordinates and dimensions.
Specify both slot count and spacing
The example requests “Model a six-slot Geneva drive” and describes the slot arrangement as “six radial slots 8.2 wide, one every 60°”. There are 6 slots, each 8.2 wide, spaced at 60°. It also specifies that each slot “ends in a semicircle whose centre is 28 from the wheel axis”. Specifying the width and end position alongside the count makes the geometry conditions to review concrete.
Distinguish the drive pin radius from the rotation radius of the pin center
The phrase “drive pin radius” alone is ambiguous: it could mean the radius of the pin itself or the distance from the drive axis to the pin center. The example gives these two values separately.
- Pin size: “Drive pin Ø8”. A diameter of 8 means the pin itself has a radius of 4.
- Distance from the drive axis to the pin center: “30 long between centres”. The distance between the drive axis center and the pin center is 30.
- Distance between the drive axis and the Geneva wheel axis: “driver axis through (-20, 15), wheel axis through (40, 15) (centre distance 60)”. The center distance between the two axes is 60.
In your text request, specify “pin diameter”, “distance from the drive axis to the pin center”, and “center distance between the two rotation axes” separately.
Give each angle a reference axis and a target part
The example defines its angular reference as “Angles in the XY plane from +X toward +Y about each part's own axis”. Angles are measured in the XY plane from +X toward +Y about each part’s own axis.
The assembly position is specified as “the crank points at 20°”. The direction of the slot passing through the pin center is given as “162.122°”, and the directions of the remaining slots as “162.122° + k·60°”. These values define the positions of the crank and slots. When requesting an intermittent rotation angle, explicitly distinguish “rotation of the drive axis” from “rotation of the wheel in one indexing step”. Keeping slot spacing and assembly position angles as separate items also makes them easier to review.
Review the assembly geometry using the example conditions
Suppose you are requesting a 6-slot assembly model like the public example for a team review. You could collect the conditions in your input as follows.
Create the driver and Geneva wheel as separate solids. Both axes are parallel to the Z axis, with a center distance of 60. Arrange 6 radial slots, each 8.2 wide, at 60° intervals on the wheel. The drive pin diameter is 8, and the distance from the drive axis to the pin center is 30. Position the crank at 20° from the line connecting the centers, and arrange one slot so that its centerline passes through the pin center.
Next, open the Geneva drive example and select Open in studio. Inspect the pin and slot arrangement in the 3D view and cross-section, and check the available dimension controls. The verification criterion in the example prompt is “The pin sits in the slot with 0.1 clearance each side”. You can compare the slot width of 8.2, pin diameter of 8, and clearance of 0.1 on each side. When changing dimensions, inspect the modified geometry in the preview before applying the change.
