CADlingo creates a rocker arm valve train with 7 parts that contact one another and move, from a single design request. The base, rocker shaft, rocker arm, valve, spring retainer, valve spring and pushrod are each generated as separate solids, with contact locations matching the coordinates specified in the request. You can open the full request and model in the rocker arm valve train example.
What the model contains
The public example measures 120 × 60 × 118 mm overall and has 7 bodies. The Ø16 rocker shaft runs parallel to the Y axis through the two lugs on the base. The rocker arm is a single solid with a Ø28 hub centered on the shaft and an attached beam extending from -30 to 40 along the arm direction. The entire arm is tilted 8° about the shaft, lowering its +X end.
The valve consists of a Ø8 stem, a Ø28 head and an R4 hemisphere at the tip. The pushrod has a Ø8 ball attached to the end of a Ø6 rod. The valve spring is formed by winding 2.5 mm diameter wire through 4 turns along a helix with a radius of 9.
Specify contact locations with numbers
The key to this example is expressing the contact conditions as coordinates.
- The hemisphere at the valve tip contacts the underside of the tilted arm at a distance of 36 along the arm direction.
- The pushrod ball contacts the underside of the opposite side of the arm at a distance of -24.
- The spring rests on the top of the base plate (Z=0) and contacts the underside of the retainer (Z=20). The helix centerline runs from Z=1.25 to 18.75, and the wire radius of 1.25 fills out both ends.
Calculated from the coordinates in the request, the distance from the center of the valve hemisphere to the underside of the arm is exactly 4, equal to the hemisphere radius. The same applies to the pushrod ball. With the two contact points at distances of 36 and 24 from the shaft, this arrangement has a rocker ratio of 1.5. In the generated part models, you can also confirm that the spring spans Z=0 to 20 and the valve tip ends at Z=49.09.
What to check in Studio
Open the example with Open in studio and use the section view to inspect the central section through the rocker arm. In one view, you can see the two points where the underside of the arm contacts the valve tip and pushrod ball, along with the spring seated between the base plate and retainer. Double-clicking a part selects the entire part, so you can view the arm on its own or select it for modification. In this example, you can vary the rocker shaft radius within a range of 7.5~8.5 mm.
Move on to the next task
Because the parts are separate, you can download STEP files for individual parts and continue reviewing tolerances and motion in another CAD application. To print a demonstration model, choose a color for each part and download it as 3MF. The part names and colors are carried into the filament slots (3MF requires a paid plan).
Use the same approach when requesting your own mechanism. Define the reference coordinate system first, describe tilted parts using their own coordinate systems and rotation angles, and specify contact locations numerically by identifying the face and point involved. Before using the design in an actual engine or device, check the materials, loads and range of motion separately.
